Router, Fence, Iron table, Freud bits

• 3.25HP Woodpeckers router Bought last year to replace PC 7518. 1/4- and 1/2-in collets. 4 hours on this. Runs great. Manufacturer says: "Spinrite Router Mounts are built from the ground up to deliver optimum performance in a router lift or a small shop CNC. It starts with industrial CNC-grade ER20 collets, a carefully machined internal taper on the shaft, and a precision collet nut. These three critical components combine to deliver significantly less run-out than the most popular 3HP class routers on the market. Then, there’s infinite speed control from a low of 10,000 rpm to 22,000 rpm. When you turn the Spin-Rite on, you’ll notice the soft-start feature ramps the speed up smoothly, saving wear and tear on both the router and the lift (or gantry). Once it’s at speed, you’ll notice minimal vibration and 75% quieter operation. It all comes together to deliver a better surface finish, less operator fatigue and longer tool life." • Rockler 32 x 24-in cast-iron router table • Bench Dog fence • Freud bits: Raised-panel set unused, 3/4-in slot cutters, Tongue-and-groove cutters, misc. others I don't need it and it's taking up space. $750